您当前的位置:首页 » 产品展示 » 频谱分析仪 » GSP-810频谱分析仪,台湾固纬GSP-810
产品名称: | GSP-810频谱分析仪,台湾固纬GSP-810 |
产品型号: | GSP-810 |
品牌: | |
产品数量: | |
产品单价: | 面议 |
日期: | 2024-09-19 |
GSP-810频谱分析仪,台湾固纬GSP-810的详细资料
GSP-810频谱分析仪,台湾固纬GSP-810
GSP-810频谱分析仪,台湾固纬GSP-810 |
|
频率范围 | 150kHz ~ 1GHz |
频率解析度 | 1kHz C.F. entry, 40Hz Sweep resolution at 2kHz/DIV |
频率显示 | 6 1/2 digit setting |
频率控制 | Digital phase locked |
频率稳定度 | +2ppm/year aging, +10ppm, 0 to 50°C |
频率频距 (Spans) | Zero, 2kHz to 100MHz/div, in a 1-2-5 sequence |
频宽 | |
解析频宽 | 3kHz, 30kHz, 220kHz, 4MHz |
解析频宽准确度 | 15% |
视频频宽 | 1.6kHz/90kHz coupled with RBW |
振幅 | |
参考准位范围 | -30dBm 到+20dBm |
参考准位准确度 | +1dB at 80MHz |
输入准位范围 | -100dBm 到 +20dBm |
杂讯准位 | -95dBm@30kHz RBW, -100dBm typical/-75dBm:150kHz ~ 10MHz |
振幅显示范围 | 75dB |
振幅准确度 | + 1.5dB typical@0dBm, 80MHz |
振幅准位线性 | + 1.5dB over 70dB |
参考准位频率平坦度 | +1.5dB over 100MHz, +2.5dB typical over entire band/+3dB:150kHz ~10MHz |
谐波突波响应 |
<-40dBc, RF input < selec |
非谐波突波响应 | <-60dBc typical down from reference level, average, 5MHz/div |
三阶交互调变杂讯 (3rd) | <-70dBc, @-40dBm input, 2 tones, 2MHz part/<-45dBc:150kHz ~10MHz |
相位杂讯 | -77dBc/Hz at 1GHz, 30kHz offset |
输入 | |
输入过载保护 | +30dBm continuous, +25VDC |
阻抗 | 50 ohm nominal |
回复损失 | <16 dB (VSWR < 1.35) |
输入衰减 | 50dB to 0dB in 10 dB steps coupled to reference level |
连接头 | Type N female |
游标 |
|
游标数 | 2 |
游标解析度 | 0.1dB, 1kHz |
游标模式 | 值, 相对值, PK->Marker, Marker->Center |
游标准确度 | 0.1dB+振幅准确度 |
其他功能 | |
记忆 | 9 组参数设定记忆组 |
Trace | Max. Hold, Average (2 ~ 32 traces), Freeze(Hold) |
设定 | Access parameters |
FM/AM DEMODULATOR | |
WB FM | 120kHz deviation |
MB FM | 75kHz deviation |
NB FM | 30kHz deviation |
AM Outputs | Internal speaker, 3.5mm stereo jack, wired for mono operation |
GSP-810 1GHz Spectrum Analyzer
Opt. 01 | Tracking Generator |
· Frequency range: 150kHz ~ 1GHz
· Amplitude range: -50 ~ 0dBm
· Amplitude resolution: 1dB
· Amplitude accuracy: ±1dB @ 0dBm, 80MHz
· Attenuation accuracy: ±1dB @ 50MHz
· Amplitude flatness: ±1dB @10MHz/div, 1.5dB @0dB, entire band
· Harmonics: < -30dBc (<-25dBc, 150kHz ~ 10MHz)
· Reverse power: < +30dBm
· Impedance: 50 ohm nominal
· Return loss: < 10dB (VSWR < 2)
· Connector: Type N female
|
|
Opt. 02 | Power Meter |
· Frequency Range: 10MHz ~ 2 GHz, usable to 2.7GHz
· Power Level Range: -20 dBm ~ +23 dBm, usable to +30 dBm
· Power Level Overload: +40 dBm < 10% duty cycle, < 10 mS duration
· Return Loss: < 1:1.35 VSWR into 50 ohms, < 1:1.25 typical
· Readout Resolution: 0.2 mW, 100 mW scale, 2 W, 1 mW scale; 0.1dB, Log scale
· Accuracy: ±(10% rdg 1digit)
· Readout: mW or dBm
|
|
Opt. 03 |
Remote Co |
· Co
|
|
OPTIo
|
|||
ATA-001 |
BNC Antenna
(An additio
|
||
ATA-002 |
Near Field Probe
(An additio
|
||
RLB-001 | Return Loss Bridge RLB Frequency Range 10MHz ~ 1GHz | ||
GTP-3000 |
Passive touch Probe Set
PR-03: Passive touch probe, SMA(F)
ADP-002: Adaptor, SMA(J/F) ~ N(P/M)
GTL-303: RF Cable Assembly, SMA(P/M), 600mm
|
||
GKT-001 |
General Kit set
ADP-002: adaptor, SMA(J/F) ~ N(P/M) x 2
ATN-100: 10dB attenuator, N(J/F) ~ N(P/M) x 1
GTL-303: RF cable assembly(SMA(P/M),RD316,600mm)x2
GSC-002: Kit box x 1
|
||
GKT-002 |
CATV Kit set
ADP-001: adaptor, BNC(J/F) ~ N(P/M) x 2
ADP-101: adaptor, BNC(J/F)75Ω ~ BNC(P/M)50Ωx 2
GTL-304: RF cable assembly(RG223,N(P/M)-N(J/F),300mm)x2
GSC-003: Kit box x 1
|
||
GKT-003 |
RLB Kit set
GAK-001: termination 50 , N(P/M) x 1
GAK-002: Cap with chain, N(P/M) x 1
GTL-302: RF cable assembly(RG223,N(P/M),300mm)x2
GSC-004: Kit box x 1
|
||
GKT-006 |
EMI Probe Kit set
ANT-01: 6cm Loop, H-Field Probe x 1
ANT-02: 3cm Loop, H-Field Probe x 1
ANT-03 6mm Stub tip, E- Field Probe x 1
PR-03: Touch Passive Probe x 1 ADP-02: N(P/M)~SMA(J/F) Adapter x 1
ADP-01: N(P/M)~BNC(J/F) Adapter x 1
Test Lead: BNC(P/M)~BNC(P/M) RF Cable x 1
Test Lead: SMA(P/M)~SMA(P/M) RF Cable x 1
|
||
GTL-301 | RF Cable RG 223 N(P/M), 1000mm |